# Offline integer instruction language L1. A word is an unsigned 16-bit integer. The high byte is opcode and the low byte is operand. A valid whole program has 1..12 words; exactly its last word is HALT (opcode 0, operand 0), and no earlier word is HALT. Other opcode/operand pairs must satisfy the table below. The program is a bounded straight-line sequence, with no jumps, memory access or external calls. L2. Arithmetic uses a uint32 accumulator initialized to the command's input. All arithmetic wraps modulo 2^32. Signed operand s is b when b<128, otherwise b-256. One instruction is retired for every inspected word, including HALT. A valid run stops after its final HALT. L3. Opcode 1 ADD accepts any byte b and computes accumulator+s. Opcode 2 XOR accepts any byte and computes accumulator XOR b. Opcode 3 MUL accepts any byte and computes accumulator*b. Opcode 4 ROT accepts b=0..31 and rotates the uint32 accumulator left b bits (b=0 leaves it unchanged). Opcode 5 SET accepts any byte and sets accumulator to signed s reduced modulo 2^32. Opcode 6 AND accepts any byte and computes accumulator AND b. Opcodes 7..255 are invalid; HALT with nonzero operand is invalid. L4. The interpreter accepts only a valid whole program, but reports raw faults deterministically: scan in order, rejecting any invalid opcode/operand, early HALT or a non-HALT last word at the first such word. Return -5, value=0 and retired including that inspected word. Active length is always 1..12. This reports a stale or incomplete execution view without invoking undefined behavior.